![]() WOL Network Configuration File Location - By default, Hyena will look for a file named "wol.dat" in the same directory as Hyena's other configuration files. The settings for the WOL options all relate to this file, which is called the "WOL Configuration File" in this documentation. This file also can contain custom network broadcast address and/or port assignments that can further tailor the WOL functionality for different environments. In order to have a consistent technique to always having the MAC address for any computer, Hyena relies upon a simple text file of the addresses for any computer that WOL support will be needed for. To configure the WOL settings in Hyena, go to Tools->Settings->WOL. ![]() Exporter Pro can also be used to export either transport or WMI card address information. In Hyena, select Computer Properties, select the Network dialog, and look at the Transports section, or use a WMI query to retrieve the address. Use the WinMSD utility to view the network card address information. Issue the command "ipconfig/all" on the command line to get all installed card addresses. There are a lot of ways to get the MAC address - some sample ways are: The MAC address is used since the computer is OFF, and any tcp, registry, etc. The key to implement WOL is to know the remote computer's (the one to be awakened) MAC address. Hyena supports the most common WOL protocol, the 'Magic Packet', whereby a specially formatted network packet is sent to the computer address to wake up. At that point, it instructs the computer to turn itself on. The general technique used by WOL-enabled network cards is that even when powered off, the computer's network card still receives a small amount of power to enable the card to 'listen' for a special signal on the network to wake up. WOL-enabled computers must have a network adapter installed in them that supports one or more remote wake up protocols. While there are a number of different protocols for implementing WOL, Hyena currently only supports the 'Magic Packet' tm technique. Quite simply, WOL is a technology that allows a computer that is turned off to be remotely turned on. ![]() That WOL magic packet can then turn the computer on, giving you access to the information saved on it.Note: Wake On Lan is a trademark of IBM Corporation. Once you select the computer you need, the Wake-on-LAN tool will generate a magic packet for a specific MAC address. Then, when your computers are powered off or in power save mode and you need to turn them on, you can use that stored list of computers to identify the one you want to turn on. It does this when your computers are powered on, compiling a list of all the computers on your network and their MAC addresses. Once Wake-on-LAN has been enabled on your computer, your Wake-on-LAN tool can begin scanning your network to collect the MAC addresses of all the computers on your network.
0 Comments
Leave a Reply. |